Latest activity
-
goodman replied to the thread Sharp GF-575 spotted in new movie!.Topic about New Retro Boombox is here, my answer too... -
RRetro radio replied to the thread Sharp GF-575 spotted in new movie!.Czy w Europie można kupić żółty kolor boombox Medion lub jego klon i kolor czarno/złoty. Czy ktoś z was kupował na Filipinach, jakie...
-
MThis unit refuses to give up its fault on the radio , tape is fine after new belts etc , switch to radio and the volume disappears there...
-
Hajidub replied to the thread Lasonic trc931.Can't remember but I think the antennae is a yellow wire that easily comes off any time the back cover is removed, very short. -
Hajidub replied to the thread The moment you know that the speaker foams need changing..Yeah, foams going or incorrectly newly installed will metallic rattle that voice coil. Weird though how increasing the bass, the...
-
Eddy replied to the thread The moment you know that the speaker foams need changing..Got a FH 10 for free 5 years ago . Foams were already gone . Previous owner did that for me:rock: -
rivetmaster posted the thread The moment you know that the speaker foams need changing. in General Chat.I could hear them starting to go. There was a slight rattle, so I thought I'd capture the moment on camera. Had to pump up the bass a... -
This post is right up my alley. I take radios to the beach all the time. If you are wanting to stick with a vintage boombox then...
-
floyd replied to the thread Technics SA-C07 internal pics.Basically it's 2 contact points with no direct connection . I wonder if we could make another contact pad . -
BoomboxLover48 reacted to jimmyjimmy19702010's post in the thread Sharp GF-9696 Idler Wheel with
Like.
Good quality tubing is the key to a good result on these decks - 5mm OD, 2mm ID - the slight increase and decrease in speed caused by... -
Superduper replied to the thread Technics SA-C07 internal pics.Those likely won't work Floyd, as those are mostly all offset and have switch sockets on both ends to prevent the rod from tweaking... -
-
hopey replied to the thread Technics SA-C07 internal pics.Time to buy a 3d printer! -
floyd replied to the thread Technics SA-C07 internal pics.https://www.ebay.com/itm/175361225337
-
floyd replied to the thread Technics SA-C07 internal pics.It seems that part is called a receiver power switch extension shaft. There are several different types on eBay.
-
hopey replied to the thread Technics SA-C07 internal pics.Time to buy a 3d printer!
