Lasonic TRC 935 & 975 belt sizes

Status
Not open for further replies.
M

Megabass

Member (SA)
Equivalent belt sizes in Diameter (mm):

SBS10.0 = 80mm
SBS6.2 = 50mm
SBS5.0 = 40mm

See attached photo for reference.

975belts.jpg
 
  • Like
Reactions: dirtydave
D

dondigitech

Member (SA)
I'm trying to replace my belts on the TRC 935 but i'm not sure if I have the right belt sizes. I bought the SBS 10.0 & 6.2s, and since there weren't any SBS 5.0s in stock i didn't get those. Anybody have any experience replacing these because the 10.0s seem a little too big to fit on deck B. The photo above doesn't look like my unit as I seem to have a separate motor for each deck. So if anyone have any photos or tips that'd be much appreciated.
 
baddboybill

baddboybill

Boomus Fidelis
Yes the 10 won't work on dual motor. You need to measure old belts and deduct about 5-10% for stretch


Bad Boy Bill
 
D

dondigitech

Member (SA)
Anyone have any idea what the correct belt sizes are for the TRC-935? The belts are in pieces and not sure which pieces are part of which belt so its kind of hard make measurements.
 
Beosystem10

Beosystem10

Member (SA)
dondigitech said:
Anyone have any idea what the correct belt sizes are for the TRC-935? The belts are in pieces and not sure which pieces are part of which belt so its kind of hard make measurements.
Click to expand...
You can use a piece of string to measure. ;-)
 
baddboybill

baddboybill

Boomus Fidelis
I replaced belts before on my 935 but forgot to put down sizes. But you might be able to buy belt kit too and fit them that way and just pick best size


Sent from my iPad using Tapatalk
 
Status
Not open for further replies.
Top Bottom