Elta 6930 / Helix Wheely Power Connection (sorting cables)

Status
Not open for further replies.
Timecop1987

Timecop1987

Member (SA)
fellas, i just opened and reworked my Elta 6930. I put everything apart and marked every single cable (or let's say: i thought so!).

Putting it together i now have 2 cables left to connect the power supply and the amp (a red and a black one) - and i did not mark 'em.

Now i dont know how to connect them with the amp-board - it's 50/50 to **** the whole thing up.

Could anybody supply a picture or advice on how to connect these 2 to the amp?

(my guess is: if you are looking from the top of the box while sitting behind it, the black cable goes with the "first" connector - which is located closer to the back-cabinet and the red one connects with the connector closer to the front-cabinet - or am i wrong?)

I would love to get a picture of your opened Elta/Helix Wheely to see how the black and the red cable is connected.


Thanks A LOT!!!
 
docs

docs

Member (SA)
It should be possible to work it out by virtue of the fact that black will be ground.
Could you possibly post a picture of the circuit board and the connectors?
 
Timecop1987

Timecop1987

Member (SA)
I attached a picture - the yellow Circle marks the Antenna-connections i guess. The Connections in the red circles are the ones im pretty unsure about!

14wbvgn.jpg
 
Timecop1987

Timecop1987

Member (SA)
Wheely5000aus said:
Your yellow circle on the first picture, those cables lead to my right speakers lol? Not the antenna?
Click to expand...

The antennas were only my first guess after i took the picture. Since i put everything together i now can assure you - my right speakers went there too :-D
 
Status
Not open for further replies.
Top Bottom