Cleaning and rebelting Sharp GF777 decks

[baddboybill]

Decided to work on my 777 decks today. Doing a good cleaning and lube, putting on new belts and cleaning and demagnetizing tape heads only other issue I ran into is one post was broken so I super glued pieces, let dry then put JB weld on and in post for added strength. Inside of box was clean so I just wiped down a bit. Now if I can only get some Fatdog labels

 

[bklyn sound]

looks great should last another 30 years beautiful 777E

 

[skippy1969]

Very nice job Bill!

 

[BoomboxLover48]

Great job Bill! Now I need to do the same on my like new GF777.

The GF777 fever is spreading!

 

[Hurb]

Great job Bill!!!!

 

[baddboybill]

looks great should last another 30 years beautiful 777E

Thanks Bro

 

[baddboybill]

Very nice job Bill!

Thanks Scott

 

[baddboybill]

Great job Bill! Now I need to do the same on my like new GF777.

The GF777 fever is spreading!

Thanks Royce it should spread

 

[baddboybill]

Great job Bill!!!!

Thanks bro

 

[baddboybill]

So she's all finished. Post works great, had to adjust motor speed on both decks and azimuth. Also had a bad solder joint from right channel left deck had to heat up joint and both channels are perfect. Listening to some Aerosmith now

 

[Cpl-Chronic]

Awesome Work, mate!!!

Now you gots to put some BOSE 2.5 ohm SUBS in the center holes & watch 'em bounce!! *jk


Just kiddin'. That is an imaculate triple7, not like my dirty disco destroyer.