JVC PC-W35 drive gear

Status
Not open for further replies.

rivetmaster

Member (SA)
I've spent some time cleaning and restoring this JVC PC-W35. The last step comes down to the drive gear on deck 2.

Are there any spares out there? I've looked in all the usual places. Does anybody 3d print these?

14.5mm diam
1.5mm id
46 teeth

I don't want to bin this boombox just for a gear wheel.

Hope you can help.
20241109_103433.jpg20241123_223748.jpg20241123_223756.jpg
 

goodman

Member (SA)
I assume that this JVC has a Tanashin cassette mechanism.
Such a mechanism you can found in many cheap boomboxes - eggs and similar...
You should find another boombox and use it as a donor.

 
  • Like
Reactions: rivetmaster

rivetmaster

Member (SA)
I assume that this JVC has a Tanashin cassette mechanism.
Such a mechanism you can found in many cheap boomboxes - eggs and similar...
You should find another boombox and use it as a donor.

That is good to know. I'll start looking. Thanks
 

rivetmaster

Member (SA)
Well, it took 2 days of searching to find these. Not easy since the listing says 'pinch rollers', but that is clearly the Tanashin mechanism.

Many thanks for the help

 
  • Like
Reactions: Tinman
Status
Not open for further replies.