Sharp GF8989 - Speakers not working.

Status
Not open for further replies.
T

Tam9n

Member (SA)
Just bought this baby a few days ago, works perfectly until I went to plug the power cable in.. and the little slider that allows a 120V or 240V was slide to the 120V position.. I didn't realise.. and living in the UK at 240v that can't have done it much good.

When turn on, everything works as it should tape deck, radio lights.. but no sounds from the speakers?
No sound out of it when headphones are plugged in too.

Any ideas? I looked at the 1A fuse beside the power input, and it seems fine..
 
baddboybill

baddboybill

Boomus Fidelis
Tam9n said:
Just bought this baby a few days ago, works perfectly until I went to plug the power cable in.. and the little slider that allows a 120V or 240V was slide to the 120V position.. I didn't realise.. and living in the UK at 240v that can't have done it much good.

When turn on, everything works as it should tape deck, radio lights.. but no sounds from the speakers?
No sound out of it when headphones are plugged in too.

Any ideas? I looked at the 1A fuse beside the power input, and it seems fine..
Click to expand...

Try with batteries :hmmm:
 
T

Tam9n

Member (SA)
baddboybill said:
Tam9n said:
Just bought this baby a few days ago, works perfectly until I went to plug the power cable in.. and the little slider that allows a 120V or 240V was slide to the 120V position.. I didn't realise.. and living in the UK at 240v that can't have done it much good.

When turn on, everything works as it should tape deck, radio lights.. but no sounds from the speakers?
No sound out of it when headphones are plugged in too.

Any ideas? I looked at the 1A fuse beside the power input, and it seems fine..
Click to expand...

Try with batteries :hmmm:
Click to expand...

Tried it with batteries, same result.. everything works but the speakers.
 
baddboybill

baddboybill

Boomus Fidelis
Yep don't sound good. Possible component failure. Maybe even amp chips. Probably going to need a scheme to figure it out....
 
T

Tam9n

Member (SA)
There is a very quiet low him actually. There is a local electronics guy I'll take it too. Would it be a costly repair?
 
Status
Not open for further replies.
Top Bottom