Hi guys, this is my first post, ive been working on restoring a sharp vz 2000 and all has gone well except there was no audio coming out of the right side.
I contact clean the balance slider and then audio returned a little, and fully if i slide it to the right, but its very problematic and i think it would be best to bypass.
The resistance i read on the L channel with the slider in the middle is 35k. should i use 2x 35k ohm resistors to bridge out the slider?
And from which leg to which leg do i bridge out??
Ive never bridged a potentiometer before, any help would be greatly appreciated..
I contact clean the balance slider and then audio returned a little, and fully if i slide it to the right, but its very problematic and i think it would be best to bypass.
The resistance i read on the L channel with the slider in the middle is 35k. should i use 2x 35k ohm resistors to bridge out the slider?
And from which leg to which leg do i bridge out??
Ive never bridged a potentiometer before, any help would be greatly appreciated..