Deck B belt swap - advice required

[richi71]

Hey folks,
My TRC 931 needs a new belt and I wondered if someone who has done this could advise on fitting it? Looking at the pics below it seems the motor housing maybe needs to be removed? If it needs removing can anyone recall which screw to remove, and can it be done in place? I'm hoping not have to remove the whole deck.

Also wondered if anyone had managed to loop the belt without removing the housing - maybe using long nose tweezers? Any tips really appreciated!

Thanks

Rich

 

[floyd]

You got the right idea, I did mine by using some dental picks to loop the belts on and you have to remove the screws on one side and loosen them on the other side and simply lift the motor up to clear the drive spindle.

 

[richi71]

You got the right idea, I did mine by using some dental picks to loop the belts on and you have to remove the screws on one side and loosen them on the other side and simply lift the motor up to clear the drive spindle.

Thanks JVC Floyd - really appreciate the tips. Cheers